This is a two component amine cured epoxy mastic coating. It is a surface tolerant, high solids, high buildproduct. Designed for application with brush and roller. 1:1 mixing ratio for easy use and reduced wastage.Specially designed for areas where optimum surface preparation is not possible or required. The product is wellsuited to touch-up and repair work during outfitting in new construction projects. Provides long lastingprotection in environments with high corrosivity. Can be used as primer, mid coat, finish coat or as single coatsystem in atmospheric and immersed environments. Suitable for properly prepared carbon steel, galvanisedsteel, stainless steel, aluminium, concrete and a range of aged coating surfaces.
Where to use
General:
Primarily designed for smaller maintenance and repair jobs.
Protective:
Recommended for offshore environments, refineries, power plants, bridges, buildings, mining equipment andgeneral structural steel.
Marine:
Outside hulls, exterior and interior areas, including water ballast tanks.
Approvals
Grain Cargo Contamination approval from NOHH
When used as part of an approved scheme, this material has the following certification:
– Low Flame Spread in accordance with EU Directive for Marine Equipment. Approved in accordance with parts 5and 2 of Annex 1 of IMO 2010 FTP Code, or Parts 5 and 2 of Annex 1 of IMO FTPC when in compliance with IMO
2010 FTP Code Ch. 8
Colors
Grey, red, buff, green, black
Application
| Spray | Suitable for airless spray application |
| Brush | Designed to achieve typical DFT in one coat. For recommendation on application equipment, see application guide. The product has delayed flow. Brush and roller marks will flatten within 5-10 min after the application. |
| Roller | Designed to achieve typical DFT in one coat. For recommendation on application equipment, see application guide. The product has delayed flow. Brush and roller marks will flatten within 5-10 min after the application. |
